BIOS Update Help!

[neoV32000]

I tried to update my Voodoo 3 2000 PCI graphic cards bios and i got the following massage:

"There is no build information for the selected hardware. Continue(y/n)?"

My current rom is 1.00.01sd.I tried to update to 2k11sd using flash utility ver 2.14(the stuff i downloaded from this site).

Can somebody help me whit this?

Another question: what drivers do you think i should use for my voodoo?
I have a win xp,288sd ram,sblive 5.1 celeron 550mhz(poor i know,but for me it fly's ).
Thnx

[Nightbird]

- You try to flash how ?

- Don't worry about your system
What drivers are you using ?
(and a question : what's your mobo ?)

[ArchAngelCD]

If you're trying to flash your BIOS from a command prompt inside of WinXP that won't work. You must flash from a clean DOS boot from a floppy disk. You can get a boot disk from http://www.bootdisk.com and if you need another site for BIOS files you can try Stanto's site. http://welcome.to/3dfxbios All the files on that site are tested and work correctly. (I'm not saying the files on 3dfxzone.it are bad, I just have never tried them but have used the ones on Stanto's site)

[neoV32000]

Happy Holidays!

I have booted my PC from a floppy disk(Win ME boot disk) and folowed the procedure that is discribed on this site(boot->type flash xxxx.rom->...).
My mobo is: Gigabyte GA-6wmmc7-1
My drivers are: Amigasport 3.0

Can somebody tell me more about my graphic card?Specifications,how good it is,what can it do and more stuff like this!

P.S. What is vsa 100?

[ArchAngelCD]

The Voodoo3 2000 is a slightly slower card than the Voodoo3 3000.
The Voodoo3 2000 and Voodoo3 3000 both have 16Mb 128bit SDRAM. The GPU and memory on the 2000 are clocked at 143MHz whereas the 3000 is clocked at 166/166.

VSA-100 is the GPU on the Voodoo4 and Voodoo5 cards.