Voodoo 3-Can it ran Gothic II properly??

[Fly-5]

Hello everyone,...
I recently got gothic II and it is playable ..for ten minutes or so then it freezes everything with weird artifacts all over the place..any suggestions ? It is certainly not due to the temperature of the VSA-100

I have the following config:

Athlon XP 2000+
Voodoo 3 3000 - Amigamerlin 3.0
SBLive Platinum
XP PRO SP1
Dirext 9.0b

I always want more..is that so bad?

[aporte]

VSA-100 is only the Voodoo4/5 family board.


For a Voodoo3 board you must use the AmigaSport 3.0 drivers kit.

The DirectX section of Amigamerlin 3.0 run only with the VSA-100 based board, like Voodoo4 4500, Voodoo5 5500 and Voodoo5 6000


I see that you have installed the DirectX 9.0b, remove it and re-install the DirectX 8.1, it is the right chose for your Voodoo3 3000


Bye bye

[Fly-5]

thnx for the advice

Hmm you were right.. I installed AmigaSport 3.0 and it is still doing the same though..
Problems occur immediately with DirectDraw operations such as unsupported mode..oh..and the game is still freezing i lowered everything down in terms of texture and model detail and all the extras..hmm i also tried the drivers from 3dhq 1.09 beta 10 but still no luck..
BTW do you know any drivers that support dirext 9.0  ?

I always want more..is that so bad?

[aporte]

Unfortunately I do not know Ghotic2.

I can say to you that you do not need of DirectX 9 on a Voodoo3 why they do not carry advantages and do not exist games that demand DirectX 9 and that they work on Voodoo3

The DirectX 9 games demand 64Mbytes of video memory and the Voodoo3 has only 16 Mbytes

DirectX 9 creates some problem with some games therefore is better if lathes to DirectX 8.1

[Fly-5]

I think I found what the problem is,,the company said that despite the fact that 16mb cards are supported 3dfx ones are not.. so I guess I have to start saving for a FX 5900 hehe thnx anyway

I always want more..is that so bad?