I added the link to my site.

Gary

QuoteOriginally posted by NuAngel

Although the one detail I do recall is the drivers being some kind of reworked 4500 driver.  Single-chip, VSA-100 (or nicknamed "101" as it had been slightly modified) based driver.  Meaning the 4500 driver was a better codebase than a 2000 / 3000 driver.

Odd as some parts (like the windows help files) indicate they were snatched from Voodoo 3.

Enjoy-

http://www.thedodgegarage.com/3dfx/rampage_2012.htm

More Everest info.



Everest info.



Before I reset it to 16 bit.



V-control.

Quake II running in software-

http://www.youtube.com/watch?v=7Db9r-aGA0A&feature=youtu.be

Does anyone know where the Rampage drivers on Rashlys website came from?

Gary Donovan

If your going to use the picture of the 3 voodoo volts on the first page please be so kind as to replace the "www.thedodgegarage.com" logo that was in it.

Or remove the picture.

QuoteOriginally posted by Obi-Wan Kenobi

true the desired speed was 183 but since all prototypes are clocked default @ 167Mhz I'd say use that default speed so would gdonovan.

Please, do not assume what I would say at any given moment.

Descent II

QuoteOriginally posted by bloodworm

looks like an STB 3dfx V4 true and blue.  should work just fine at 1.5V.  it DOES have both notches.  this board is DEFINATELY NOT a powercolor board.

It's a Powercolor clone and chances are runs at 3.3 volts AGP just like the Powercolor V4's.

I would try with a Voodoo 3 since by default it is a 3.3 volt board.

Updated.

Quote

Please delete all my entris from the incompatibility list. The card was actually broken.

Please let me know which entries you sent in.

Quote

I certainly wouldn't pay up and above US$200 for a dead/potential fix Voodoo 6000 anyways.

Then chances are you will never have one.

QuoteOriginally posted by NitroX infinity

You just need to solder on the chips and flash the card with a modified BIOS.

Not true.

The second bank of SDRAM will NOT be seen by the board unless the strapping resistor is installed regardless of bios.

http://www.thedodgegarage.com/3dfx/v6k_faq.htm

benchmarks will be on a new page in a week or two, this one is large enough as it is.