hi

i need help to set up my drivers right...
i want performance not quality (FRAMERATE IS LIFE)
which driver should i choose?
which settings on the card?
(there are many in the 3dfx hub, which i doesn't understand whats faster...)
wanna get more 3Dmarks 2001 with it (at moment at 4014 @ 1024x768x32)

greetz SnaG

hmm ok, i'll pick the 8k5a2+ cause its newer than the 8k3a+

greetz SnaG

hmm, any other opinions??

greetz SnaG

hi there

i know this is a well known topic,
but i am unsure which motherboard i should take..
This things should run on it, without any problems:
- V56K rev3700
- 3x 1GB Infineon CL2.5 DDR333
- Adaptec 29160 SCSI Controller (motherboard must allow boot on SCSI)
- Barton 3000+  FSB333

http://www.thedodgegarage.com/3dfx/v6k_faq.htm

the site says i can pick a Epox 8k3a+ or a 8k5a2+
which should i pick?
or are there any other opinions?

greetz SnaG

hmm ok

thx again

another question, can the card blow up (hint se-66)
if i put it in the false kt333 board ?
like a epox 8k5a2+ ? (the 8k5a was tested by logicalmadness)

greetz SnaG

thank you guys:)

very interesting,
but if take a closer look on it there are 5 or 6 pins connected to the bios of the card

i am looking for a compatible motherboard for a v56k rev3700
i know that it must be kt333 bu there are many of them:
Epox 8k3a+ : VIA KT333 AGPset (KT333CE+ VT8233A/8233) <-- will that work?

gr33tz SnaG